-36-
Defect
Cause
Elimination
Machine stops while cutting is in
process
Mains failure
Check mains back-up fuses
Machine overloaded
Reduce feed speed
Workpiece jams when feeding
Blunt saw blade
Stop rail of the universal stop is
not parallel to the saw blade
Hold workpiece and turn motor off
immediately. Then exchange the
saw blade
Readjust the stop rail, see chapter
5.6
Burn marks on the cut surfaces
The saw blade used is unsuitable
for the task or blunt
Replace saw blade
Chip outlet blocked
Operation without extraction
Remove chips while the machine is
switched off (see Fig. 8 - page 3).
The protective sliding cover 52
must be opened. To do so, detach
screw 51 with the Allen key 22. Pull
the locking recess 50 on the saw
guard downwards and pull the
protective sliding cover forward.
The chips in the chip duct can now
be easily removed downwards.
Afterwards close and engage the
protective sliding cover again.
Caution! Retighten screw 51.
Extraction too weak
Use an extraction unit, which
guarantees an air speed of at least
20 m/s (65.6 ft/sec.) at the
extraction connection piece
Wood particles in the chip ejector
Remove chips while the machine is
switched off (see Fig. 8 - page 3).
The protective sliding cover 52
must be opened. To do so, detach
screw 51 with the Allen key 22. Pull
the locking recess 50 on the saw
guard downwards and pull the
protective sliding cover forward.
The chips in the chip duct can now
be easily removed downwards.
Afterwards close and engage the
protective sliding cover again.
Caution! Retighten screw 51.