DD40P
18
01/2022
5.4
Drilling with accessories
5.4.1
Drilling with ancillary guide fence set
The ancillary guide fences permit different edge distances.
Edge distances:
-
A = 32 mm [1.26 in] / for hole rows
-
B = 43 mm [1.69 in] / as repositioning guide fence
-
C = 32 mm [1.26 in] / for miters
-
D = 7.5 mm [0.31 in] / as parallel guide fence for
batten processing
Fig. 15: Ancillary guide fences
The ancillary guide fences can be plugged into the
guide fence surfaces of the base plate.
Fig. 16: Plug-in locations for ancillary guide fences
5.5
Working with special accessories
Various special accessories are available for the machine. An overview can be found in chapter 8 Optional
accessories.
Some utilization methods are explained below.
5.5.1
Drilling with dowel gage
Use the following procedure for drilling
horizontally with the dowel gage:
1.
Place the dowel gage flush with the face of the
workpiece and draw a marking on the left and
the right.
2.
Position the dowel gage at the markings and
clamp it tight.
Fig. 17: Drawing the position for the dowel gage