Example:
Set alert report of 600 miles threshold.
Command: SG205,600
Response: @352238020015913,205,600!
SG206: Set low battery detection
Command: SG206,<TH_BAT>,<PS>
Response (SMS): @<ID>,206,<TH_BAT>,<PS>!
–
Where <TH_BAT> is main battery voltage threshold, in volt.
–
Where <PS> is the GPS power saving mode. In power saving mode the GPS will get a fix and sleep
for 10min, before wake up and fix again. The MT-01 will go under power saving mode when battery
back-up is too low, or when ignition is off.
For the format of this alert message, please refer to event number 608 described in chapter 6.
Default setting: <TH_BAT> = 0, <PS> = 0
Example:
Set low battery detection to 10V and GPS power saving on battery backup.
Command: SG206,10,1
Response: @352238020015913,206,10,1!
SG207: Set battery disconnect detection
Command: SG207,<INT_MB>,<ALT_MB>
Response (SMS): @<ID>,207,<INT_MB>,<ALT_MB>!
–
Where <INT_MB> is the periodic report interval in
seconds
. If it is set to any value between
10 and
65000 with increment of 10
, then periodic location reporting will be enabled with reporting interval
as the value set. If value set to 0, then periodic location reporting will be disabled.
–
Where <ALT_MB> is to enable/disable alert message which is triggered by battery disjunction.
For the format of this alert message, please refer to event number 609 (battery disconnected) and 610
(battery reconnected) described in chapter 6. For the format of the periodic report, please refer to event
number 707 described in chapter 6.
Default setting: <INT_MB> = 0, <ALT_MB> = 0
Example:
Set battery disconnection alert and report every 15min.
Command: SG207,900,1
Response: @352238020015913,207,900,1!
SG208: Set Heartbeat reporting / Power up alert
Command: SG208,<INT_HB>,<ALT_PU>
32
Confidential, the whole document is the sole property of Maestro Wireless Solutions ltd.
3603-9, 36/F., 118 Connaught Road West, Sheung Wan, Hong Kong
