V0.1– Oct-14
User’s Manual
Page 13 of 17
6.3 ICC Jumper
Figure 10: ICC jumper
As long as the VCC DIP switch is “ON” the ICC jumper is bridged. By putting the
VCC
DIP switch to the OFF position the current draw of the A2135-H GPS receiver can
be
measured directly by connecting a low resistance measurement device to the ICC
jumper.
The low resistance measurement device should be connected before VCC is
switched off!
7 NMEA Port
•
Default setting: 4800 baud, 8 data bits, no parity, 1 stop bit, no flow control!
•
Standard NMEA-0183 output on NMEA, baud rate selectable.
•
Standard USB connectors
