Adjusting the MadStad Brackets
The knob screws release the brackets allowing the windshield to slide and tilt. These
knob screws must always be tightened securely before riding. DO NOT attempt to
adjust the brackets while riding! You must come to a complete stop before making
adjustments. Also make sure that you do not set the windshield in such a way that
causes your handlebars or hand guards (if installed) to hit the windshield when
turning, or before reaching full lock.
To make adjustments, loosen the knobs 1-2 turns and set the windshield so the
top edge is at about your chin level as you look straight ahead while seated on
the bike. Set the angle at approximately 60 degrees. (Use the angle guide on the
back page of this manual as a guide.) Tighten the knobs and go for a ride to see
if you now have smooth airflow over and around your helmet. Do this on a
calm day if at all possible; windy days make it hard to judge the airflow. Don’t
ever try to adjust the mount while in motion!
To try a different windshield position, bring the motorcycle to a complete stop
and out of traffic. Loosen the two knob screws and tilt the windshield forward
or back 2-3 degrees or so, and/or adjust it up or down if necessary. Re-tighten
the knobs and go for another ride. Continue experimenting with different
positions at different speeds until you find a combination of height and rake
angle that eliminates buffeting and gives a smoother ride.
Releasing the MadStad System
The brackets and windshield can be removed as one unit from the mounting
base. Simply lift and rotate the locking keys down off of the top mounting
spools, then tilt the shield/brackets assembly forward and lift off of the bike.
Use the crossbar as a grip if you don’t have anything attached there. Re-attach
by doing the reverse.