33
the reduced-volume audible scan available during these modes to search the CD
until the laser pickup reaches the passage you want to hear.
(Assuming your CD
player is set for audible rather than silent scanning. If not, see
Special Functions
.)
As soon as you release the button, play resumes.
If you search past the beginning or end of a track, the laser pickup will move on
to the previous (or next) track. If you try to search forward past the end of a CD
or program, the laser pickup will stop at the end of the last track. If you try to
search backward past the beginning of a CD or program, the laser pickup will
stop at the beginning of the first track of the disc (or playlist).
Direct Time Access
You may use
time
on the Remote Control to begin play at a specific
time
on the
disc.
1. Select the desired track using either
next
and
previous
or the
numeric keypad
on the Remote Control.
2. Press
time
, then press the numbered buttons corresponding to
when you would like play to begin. (The numbers you select will
appear in the
time
portion of the display.)
3. To begin play at that point, press
play
.
Note: The time you select depends on the selection you’ve made
with the display mode button: elapsed or remaining, CD or track.
For example, if you want to begin play one minute and thirty seconds into track
2, select track 2 by pressing
2
on the remote control. Press
time
, enter
1 3 0
, then
press
play
. (This example assumes that the most recently used display mode was
elapsed time on track
.) If you do not press
play
, the Nº39 will timeout after ten
seconds (that is, it will “forget” that you had begun to do something, and revert to
normal operation).
Alternatively, you might want to set the Nº39 to play music for a specific period
of time. Say you’d like to listen to music until the evening news begins in 30 min-
utes. Make sure both the
time on disc
and
time remaining
LEDs are on (indicat-
ing
time remaining on disc
, the default display mode when in
stop
); press
time
;
enter
3 0 0 0
; and press
play
. This sequence will direct the Nº39 to a point 30
minutes from the end of the disc, and engage play at that point. When the music
ends, you will know it is time to turn on the news.
Pause
To suspend play while a CD is playing, press
pause
. To resume play at the same
point, press
pause
again.
If left in
pause
for about two minutes, the transport will stop spinning and the
laser will turn off (thereby enhancing the longevity of both). This
extended
pause
mode will be indicated by the display showing a slowly flashing quotation
mark (
||
) as a reminder that you are in the
extended pause
mode (since this
mark mimics the double bars used to indicate
pause
).
Alternatively,
extended pause
may be engaged by pressing
and holding
the
pause
button until the double bars begin to blink.
Repeat Disc
To repeat (continuously) all tracks on a CD, press
repeat
until the
disc repeat
LED is lit. To return to normal play, press
repeat
(or
rpt disc/trk
on the remote)