MADECO MD-M9, Operation Manual

Page: 7 / 11

Item-1
: For
MD-M2 flow sensor, the sensor K factor is:0.065mL/p
To measure instantaneous flow . The measuring unit is
“
mL/M
”
To measure total flow
volume. The measuring unit is “
mL
”
1.Setting Procedure
1) Wiring;(Refer the Wiring)
2) Power on;
3) Press the
SET
key over 5s , to enter the setup mode
4) Tap press
SET
key, to rolling down the parameters;
5) Rolling down to the parameter [C-D-P], to
modify the Decimal.
To press the lefe key,the parameters will flash ,to press the
up or down key to adjust the Decimal point.Press the
SET
key to comfirm.
6) To press the
SET
key to set
[C-P] set
the total flow parameters . press the left key the
cursor blink values of increasing upward
14 Reset
In normal display, press this key to
perform the count or time zero setting
12+13 Complex
Any setting screen, press the key
composite key to return to the normal
display
G. Example