Page 3
For technical questions, please call 1-888-866-5797.
63728
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document
including all text under subheadings therein before set up or use of this product.
Bearing Removal From Rear of Knuckle
1. Choose an appropriate sized Plate (001 or 002),
Sleeve (14, 15, 17, 18 ) and Bushing (1-13) for
your vehicle. Sleeve should be larger than the
diameter of the bearing and the Plate should
be a snug fit into the sleeve. Bushing should be
slightly smaller than the diameter of the bearing.
2. Use Bolt (19), two Washers (20), Nut (16). With
an appropriately sized Sleeve, Bushing and
Plate to construct the removal assembly.
Bolt (19)
Washer (20)
Plate
Sleeve
Bushing
Washer (20)
Nut (16)
Knuckle
FWD (Face)
Rear
3. Place Sleeve, Plate, Washer and Bolt
head at the rear of knuckle with Bushing,
Washer and Nut at the face of knuckle.
4. Hold Bolt head with wrench (not included) and
turn Nut to force the bearing out of the knuckle.
5. Remove assembly and bearing from knuckle.
Bearing Removal From Face of Knuckle
1. Choose an appropriate sized Plate (001 or 002),
Sleeve (14, 15, 17, 18 ) and Bushing (1-13) for
your vehicle. Sleeve should be larger than the
diameter of the bearing and the Plate should
be a snug fit into the sleeve. Bushing should be
slightly smaller than the diameter of the bearing.
2. Use Bolt (19), two Washers (20), Nut (16). With
an appropriately sized Sleeve, Bushing and
Plate to construct the removal assembly.
Bolt (19)
Washer
(20)
Bushing
Sleeve
Plate
Washer (20)
Nut (16)
Knuckle
FWD (Face)
Rear
3. Place Sleeve, Plate, Washer and Nut at
the face of knuckle with Bushing, Washer
and Bolt head at the rear of knuckle.
4. Hold Bolt head with wrench (not included) and
turn Nut to force the bearing out of the knuckle.
5. Remove assembly and bearing from knuckle.
