MadBoy BOSS-08, Owner'S Manual

Page: 6 / 24

Connecting the Subwoofer
WWW.MADBOY-AUDIO.COM
6
MIN MAX
VOLUME
50 Hz 150 Hz 0° 180°
L.P.F PHASE
R
L
R
L
HIGH LEVEL INPUT
LINE
IN OUT
L
AUDIO
SOURCE
R
POWER INPUT
AC 100-240 V, 50/60 Hz
O
1. Connect the line level audio source to LINE IN.
2. Connect the power cord to power input in the back panel and to mains power outlet.
3. Turn on the subwoofer by setting the main power switch to I position.
I
4. Adjust the volume until the sound of the subwoofer complements the soundscape of the main
speakers as desired.
5. Adjust the Low Pass Filter (L.P.F) setting. Turn clockwise to increase frequency range the subwoofer
plays. If bass seems too strong in certain frequencies, try a lower L.P.F setting. Note! In case you are
adjusting the LPF from your home theather amplifier, set this fully clockwise (150 Hz).
6. Adjust the phase to match the phase of the main speakers. First set the phase to 0 and play music. °
Then turn it fully clockwise to 180°. Set it to point where you will get the loudest bass.
MIN MAX
VOLUME
50 Hz 150 Hz 0° 180°
L.P.F PHASE
Notice:
Ÿ If your audio source has mono or subwoofer output, you can connect using single RCA cable.
Ÿ If your amplifier doesn’t have line output or subwoofer output, you can connect from
amplifier’s high level speaker output to subwoofer’s high level input using speaker cable.
Ÿ Do not connect audio to both LINE IN and HIGH LEVEL INPUT. Use only one of them.