Mad Dogg Athletics spinner SPORT, Owner'S Manual

Page: 9 / 16

» spinner® spOrT Owners manual
7
WARNING!
save these instructions
THE FLYWHEEL MOMENTUM OF THE BIKE WILL KEEP THE PEDALS TURNING EVEN
AFTER THE USER STOPS PEDALING OR IN THE EVENT THE USER’S FEET SLIP OFF
THE PEDALS. DO NOT DISMOUNT THE BIKE OR ATTEMPT TO REMOVE YOUR FEET
FROM THE PEDALS UNTIL BOTH THE PEDALS AND THE FLYWHEEL HAVE STOPPED
COMPLETELY. FAILURE TO COMPLY MAY LEAD TO LOSS OF CONTROL AND SERIOUS
PERSONAL INJURY.
5
4
4) INstALL tHE HANdLEBARs
Unscrew, pull out and hold the handlebar
pop-pin. Slide the handlebar post all the
way into the handlebar tube. Release the
handlebar pop-pin. Adjust the handlebars to
make sure pop-pin is engaged. Tighten the
handlebar pop-pin securely.
5) INstALL tHE PEdALs
note:
The pedal spindles are marked “L”
(left) and “R” (right) to aid in assembly. Left
and right are referenced from a seated
position on the bike. Be sure to install the
pedals on the correct side of the bike.
Turn the resistance knob all the way to the
right until crank arms are immobilized. Install
the left pedal on the left pedal crank. Use the
multi wrench supplied and turn the left pedal
spindle
counterclockwise
to tighten. Install
the right pedal on the right pedal crank. Use the multi wrench supplied and turn
the right pedal spindle
clockwise to tighten. Be sure both pedals are tightened
securely.
6) LEVEL tHE BIKE
Move the bike to the location where it will be
used. Your Spinner® Sport requires 4’ x 6’ of
floor space for proper operation. Rock the
bike gently to check for wobble. If needed,
use the leveling adjusters under the front and
rear stabilizer bars to steady the bike.
6