MACROZA M80, User Manual, Page: 12 / 24

MACROZA wall chasers’ cutting device is a Tungsten Carbide tipped milling cutter.
There are seven different types of milling cutters depending on required cutting
measure (depth x width):
12
NOTES
Cutting width and depth might vary depending on
milling cutter’s level of wear.
• For cuts wider than 50 mm, make two parallel cuts
side by side
• For gear or switch boxes, make two additional parallel
cuts on each side of the existing cut.
STANDARD SERIES RZ
RZ Standard milling cutters
are able to work on softer
materials such as hollow clay
bricks, AAC blocks, limestone
blocks or semi-hard solid
clay bricks and hollow
cement blocks
PREMIUM SERIES RD
RD Premium series have been designed to work
on the hard building material with the exception
of concrete, pre-cast concrete or stone.
Working on standard masonry materials,
MACROZA RD Premium series increase
productivity in up to 40% as opposed to the RZ
standard cutters.
MILLING CUTTERS
RZ1-RD25 RZ-RD12 RZ-RD150 RZ-RD105 RZ-RD11 RZ-RD115 RZ-RD10
RZ or RD 10: 25 mm x 25 mm (suitable for all Macroza models)
RZ or RD 105: 30 mm x 30 mm (suitable for all Macroza models)
RZ or RD 11: 35 mm x 25 mm (suitable for all Macroza models)
RZ or RD 12: 45 mm x 15 mm (suitable for all Macroza models)
RZ or RD 115: 35 mm x 35 mm (suitable for M95 and SC200 only)
RZ or RD 125: 40 mm x 40 mm (suitable for M95 and SC200 only)
RZ or RD 150: 50 mm x 50 mm (suitable for SC200 only)