Thank you for purchasing either a Macnaught TR205 Drum
Trolley, OS100 Oil System or GS100 Grease System. All
three Systems have been designed to suit 205 litre or 180kg
drums.
Macnaught also manufacture a complete range of
retractable hose reels, oil dispensing nozzles, fuel pumps,
oil pumps, positive displacement flowmeters, greasing
equimment and a complete range of accessories to suit
all your fluid handling requirements.
Please take a few moments to read through this manual
before using either your TR205 Trolley, OS100 Oil system or
GS100 Grease System. Please read and retain this
instruction to assist you on the assembly and installation of
the products listed above. Pay special attention to any
warnings or cautions mentioned in this instruction manual.
INSTRUCTION MANUAL
The TR205 Trolley carton contains:
1 x Trolley base, 1 x Trolley handle assy, 2 x wheels, 1 x Brake
Castor, 1 x Safety chain, 4 x 10mm x 25mm long Bolts, 4 x
10mm Nuts, 8 x 10mm Washers, 4 x 16mm Washers, 2 x
Cotter pins, 2 x 5/16” x 1” long Set screws, 1x Instruction
manual.
10) The Safety chain is attached to the hooks located on
either side of the handle.
* Always disconnect the air supply before moving the
trolley.
TR205 DRUM TROLLEY
1
OS253
1007
0009
Fig1
2) Lift the brake lever to unlock.
TR205 Litre Trolley / OS100 Oil System / GS100 Grease System
GENERAL INFORMATION
TR205 TROLLEY ASSEMBLY
1) Remove all the components from the carton.
2) Fit a 16mm washer to the wheel axle on the trolley base.
3) Fit one of the wheels to the wheel axle.
4) Fit another 16mm washer after the wheel and secure the
wheel in place with one of the cotter pins supplied.
5) Fit the other wheel to the trolley base as detailed above
steps 2 to 4 ).
6) Line up the 4 holes on the Castor plate with the 4
mounting holes on the trolley base.
7) Secure the castor to the trolley base by using the 10mm
bolts, washers and nuts supplied. Tighten all bolts and
nuts securely.
8) Slide the trolley handle into position.
9) Secure the handle to the trolley base by fitting the two
5/16” set screws to the screw holes located directly
under the handle on the under side of the trolley.
Caution
* Do not leave the trolley on an incline or unattended.
* Always apply the wheel brake when the trolley is not
being moved.
* Always use the safety chain to secure the drum.
HOW TO USE THE CASTOR BRAKE
1) Press brake lever down to lock.
Note: To adjust the brake tension, tighten the cross bolt
holding the brake. Check brake function weekly.
FITTING THE DRUM ON THE TROLLEY
1) Tilt the drum and slide the trolley as far under the drum as
possible.
2) Press the brake lever on the castor “down” to lock the
trolley in position.
3) Slide the drum Fully into position on the Trolley.
4) Secure the safety chain around the drum.