ME042 Issue 15 © 2014
2
Register rotation
1) Unscrew the 4 screws holding the register assembly
2) Carefully lift off the complete register assembly from the
register base
3) Rotate the register assembly to the desired position.
4) Carefully re-fit the register assembly to the meter body.
Do not force the register assembly when re-fitting to
the register base. Ensure that both the register drive
gear and meter drive gear are properly engaged before
replacing the register screws, or damage may occur.
5) Replace the 4 register screws.
Meter disassembly
1) Ensure that the fluid supply to the meter is
disconnected, and the line pressure is released
before disassembly.
2) Unscrew the 4 screws holding the register
assembly.
3) Carefully lift off the complete register assembly from the
register base
4) Remove the 4 gear box cover screws and carefully
remove the gear box cover assembly, o’ring and gears
from the gear box.
NOTE: The gear on the gear box cover
assembly should not be removed. If there is any wear or
damage the complete gear box cover assembly should be
replaced.
5) Remove the 4 hex bolts holding the register base to the
meter body remove the meter body o’ring and both rotors
Check all components for wear or damage and replace as
required.
Meter reassembly
1) Clean all components before reassembly.
NOTE:
The rotor with the drive pinion must be fitted to the side of
the meter body, which has D/Gear marked on the meter
body, (see fig 3).
2) Replace the rotors so as they are at 90
O
to each other,
(see fig 3). Check the rotor rotation by turning either of the
rotors. If the rotors are not in mesh correctly or do not
move freely remove one of the rotors and replace it
correctly at 90
0
to the other rotor. Recheck the operation of
the rotors.
3) Insert o’ring into the o’ring groove on the register base
4) Carefully align the spring pins on the meter body to the
spring pin holes on the register base
D/GEAR
(fig 3)
5) Replace the 4 hex screws and nuts and tighten firmly.
6) Insert gear marked L1(Litre) or Q1 (Quart) onto the
shaft located in the gear box.
7) Place the gear marked L2 (Litre) or Q2 (Quart) on top
of gear 1. The hole in gear 2 should be positioned to align
with the output shaft hole in the gear box.
8) Place the gear marked L3 (Litre) or Q3 (Quart) onto the
same shaft as gear 1.
9) Insert the gearbox cover o’ring into the o’ring
groove on the gear box cover
10) Fit the gear box cover assembly by carefully inserting
the output shaft through gear 2 and into the output shaft
hole in the gear box.
11) Fit the 4 gear box cover screws and tighten securely.
12) Rotate the register assembly to the desired position.
13) Carefully re-fit the register assembly to the meter
body. Fit 4 screws and tighten firmly.
14) Press the reset button to reset the batch total to zero.
15) Test the meter by turning the rotors with a finger or by
applying low air pressure. (No more than a good breath)
to the inlet port of the meter. This will confirm the meter is
operating correctly and that the number wheels are
ascending.
DM150 Meter and Filter assembly
FLOW
(fig 4)
CAUTION
Note:
Order DM150-01 for Meter and Filter assembly complete
Note:
Order HA1s for filter assembly only
