Mackworth M Series, User Manual

Page: 8 / 36

M-Series Mobile Floor lift User Manual Page 8 of 36 Part No. 9995xx / Rev.Draft / Aug 2019
5. Floor lift assembly instruction
The Assembled Floor lift Carton Contains:
•
Base fitted with 2 brake casters rear and 2 non-brake casters front
•
Mast and boom assembly
•
2 Point spreader bar complete with cover, and new M10 Bolt and
Nylon Lock Nut
•
Mast locking hand wheel
•
Hand set
•
Battery Pack
• Control box
•
Actuator
•
Battery charging cable.
a. Carefully open the box ( SAFETY NOTICE - Do not use a sharp knife /
edge) remove all loose parts / excess packaging from the carton.
b.
Carefully lift the floor lift out of the carton ( SAFETY NOTICE - 2-person lift
recommended or remove the end of the carton and wheel the floor lift
out). Place the floor lift on a flat surface and ensure the rear braked
casters are locked
.
c. Remove the black mast locking hand wheel from the top of the
assembly, then carefully lift the mast upright ensuring the mast drops
into position. ( SAFETY NOTICE - Please ensure both hands are on the
handles when lifting the mast into position, possible risk of finger trap).
d. Ensure all cables are routed correctly and are clear of the base / mast
when lifting into position.
e. When the mast if fully engaged with the base, fit and fully tighten the
mast locking hand wheel. ( SAFETY NOTICE - Ensure this is tight and
locked into position before using the floor lift). Remove the strap and
buckle retaining the spreader bar, the strap should be kept safe and
should be used if the floor lift is folded for transport.