Before You Begin
•
Visually check the Chipper Knife for damage each time you use the machine.
NOTE:
Check for shaft movement while starting the Engine. If the shaft does
not turn, STOP the Engine and clean out the Shredder-Chipper Hopper(s) as
instructed on page 14.
•
ALWAYS operate the shredder-chipper from the Operator Zones (Figure 5).
•
When viewed from the Chipper Hopper side the Rotor turns in a clockwise
direction.
•
NEVER assume you know where the Chipper Knife is. You do not know
where it is.
•
ALWAYS stop the Engine when leaving the Operating Zone or when moving
the machine.
Shredder
Figure 5
11
Summary of Contents for SC300M
