www.mackie.com
PHONE:
425.487.4333 •
TOLL-FREE:
800.898.3211
ThumpBST Speaker Setup Guide
Knowledge Base
http://mackie.com/products/thump
In this document, we will walk through some basic steps of setting up two Thump15BST loudspeakers with one Thump18S, and
a ProFX8v2 mixer. This document will also go over connecting two input sources including a microphone and an iPad.
For this set-up you will need the following cables:
4x XLR Male to XLR Female cables:
https://www.sweetwater.com/store/detail/XLR30
1x 1/8” TRS to TS “Y” cable:
https://www.sweetwater.com/store/detail/CMP153
4x IEC Power Cord (which should have been included when you bought your equipment):
https://www.sweetwater.com/store/detail/PWC148
Set-Up
The first thing to do is to get your two Thump15BST loudspeakers and Thump18S in position for your gig, preferably close to
a reliable power source. There are a couple of ways you can set-up your Thump15BST loudspeakers. One way is to use your
Thump15BST loudspeakers with speaker tripod stands. In this example, we are only using one Thump18S subwoofer so we will
be using two speaker stands to mount our Thump15BST loudspeakers.
Page 1
Cables Needed
