Mackie HD1501, Service Manual

Page: 10 / 40

Page 10 of 40
HD1501 SERVICE MANUAL
Page 10 of 40
1
2
3
4
5
6
1
2
3
4
5
6
A B C D
A
B C D
0033242-XX-B_ASSY_FNL_FS15
REVISION:
DRAWING NUMBER:
ONE MAIN STREET, WHITINSVILLE, MA 01588 USA
PRO ENGINEER
TITLE:
SCALE:
2
2
LOUD Technologies Inc.
0033242-XX
B
B
SHEET OF
0.250
DWG ASSY FINAL
HD1501 [FS15]
NOTES: 1. APPLY THREAD SEAL COMPOUND, ITEM 23, BEFORE ASSEMBLY. 2. - CABLE CLAMP TO LINE UP VERTICALLY WITH HOLE IN BAFFLE - LED WIRES MUST PASS THROUGH CABLE CLAMP BEFORE ATTACHING TO PCBA - ROUTE WIRES BETWEEN LED PCBA AND GRILLE TO KEEP AWAY FROM WOOFER - PULL LED WIRES BACK THROUGH HOLE IN BAFFLE THEN SEAL HOLE WITH ITEM 19 - LEAVE ONLY ENOUGH SLACK TO ALLOW REMOVAL OF GRILLE ASSEMBLY 3. CONNECT RED WIRE TO LF+ /BLACK WIRE TO LF- 4. APPROX. 300 MM OF CABLE ASSY TO BE ON AMPLIFIER SIDE OF WIRE GLAND AFTER ASSEMBLY. 5. AFFIX S/N LABEL FROM FINISHED GOODS BOM, 2 PLACES 6. PORT TOP WALL, TOP AND SIDE WALLS OF CABINET, AND AMP CAVITY WALL TO BE COVERED WITH WHITE POLYESTER FIBER FOAM, BOM ITEM #22, HELD IN PLACE WITH STAPLES. CAUTION: DO NOT BLOCK ENTRANCES TO THE TWO PORTS.
SEE NOTE 4
SEE NOTE 5
SEE NOTE 5
SEE NOTE 3
SEE NOTE 2
SEE NOTE 2
14 1
24 1
24 1
18 1 17 1
Final Assembly Diagrams