![background image](http://html1.mh-extra.com/html/mack/chm-2010/chm-2010_operators-handbook-manual_686196098.webp)
90 OPERATION
Troubleshooting
The following checks may be used to diagnose any problems which may arise with Remote
Keyless Entry system operation. Remember to check all transmitters.
1 Lower the windows, turn the ignition key to the OFF position and close the doors.
2 Stand near the driver’s side door, aim the transmitter at the vehicle and operate both
functions of the transmitter. Repeat for all transmitters, if applicable.
•
If a single function on one transmitter is inoperative, replace the transmitter.
•
If all functions on any of the transmitters are inoperative, reprogram all transmitters
and repeat the troubleshooting procedures. Refer to the "Programming the
Transmitter" section.
•
If one transmitter cannot be programmed, replace the battery in the transmitter. Refer
to the "Battery Replacement" section.
3 If all functions on all transmitters operate, stand approximately five feet from the vehicle
(at several points around the vehicle), and check the operation of all transmitters at
each point.
•
If one transmitter does not operate at some point where another transmitter does
operate, replace the battery in the transmitter that does not operate.
•
If all transmitters operate approximately five feet from the vehicle, the system is
operating properly and no repairs should be attempted.
Programming the Transmitter:
1 Turn the ignition switch to the ON position.
2 Access the keyless entry module, located behind the D-Panel.
3 Push the Program switch on the keyless entry module three times. The program LED on
the module will be solid, to indicate you are now in the Transmitter Programming Mode.
4 Press any button on one of the transmitters until the horn responds with a chirp and the
LED will flash once, to confirm the first transmitter is now programmed.
5 If necessary, repeat Step 3 to program the 2nd, 3rd and 4th transmitters.
Note:
If more than four transmitters are programmed, the system will only retain the last
four transmitters programmed.
6 To exit Programming Mode, turn the ignition switch to the OFF position, or simply wait
15 seconds. The LED will be off to confirm exit.
Summary of Contents for CHM 2010
