Mack CHM 2010, Operator'S Handbook Manual

Page: 59 / 232

INSTRUMENTS AND CONTROLS 51
7. Grade Gripper (Amber) (SCR) – Grade Gripper provides anti-roll back
assistance during the transition from a stopped position to starting on a grade.
7. Integrated Temp-A-Start (Amber) (If Equipped) (DPF) – "Integrated
Temp-A-Start" saves fuel by reducing the amount of time spent idling to keep the
vehicle’s batteries charged, the engine warm, or the cab and sleeper comfortable.
Once the optional ’Integrated Temp-A-Start’ feature is activated via a dash switch,
the system will automatically start and stop the truck engine. Safety overrides
prevent the system from activation if the transmission is in gear, the hood is up, or
the parking brake is released. Integrated Temp-A-Start voltage and temperature
target settings are fully programmable through either VCADS service support
software, or, if enabled via the Co-Pilot instrument cluster display
8. Pre-Heat Start Indicator (Amber) (If Equipped) – Indicates that the intake
pre-heat is enabled. Wait to start engine until light goes out.
9. Check Transmission (Amber) – A amber tell-tale light that illuminates when
transmission oil temperature reaches a pre-determined level (depending on
transmission make and model) indicating an overheat condition or It may also come
on if an active fault code is present in the transmission.
10. Electronic Malfunction Indicator (Amber) – Illuminates when V-MAC®
detects an electronic malfunction. Refer to the V-MAC® IV Vehicle Management
and Control with Co-Pilot® Display Operator’s Guide . The electronic malfunction
lamp may turn on when operating the vehicle in a bob-tail mode with the engine
brake turned on and cruise control active. Cruise control will become inoperative
but can be reset by shutting off, then restarting the engine. This condition can
be corrected by resetting the "Service Brake Fault Threshold with Engine Brake"
function. Refer to V-MAC® IV Customer Data Programming.
Note: Consult the appropriate vendor engine manual if your vehicle is not equipped with a
MACK engine.
11. Check Lamps
12. High Beam Indicator (Blue) – Indicates that high beams are on.
13. Parking Brake Indicator (Red) – Indicates that the parking brake is engaged.
14. Left Turn Signal Indicator (Green) – Flashes green when the left turn signal
is activated.