GB - 10
3. Grasp starter handle and pull rope out
slowly until it pulls harder. This is the
compression stroke. Let rope rewind
slowly. Then pull rope with rapid
continuous full arm stroke to start engine.
Allow rope to rewind slowly.
IMPORTANT:
DO NOT let starter handle snap
against handlebar.
4. Repeat until engine starts. (If engine does
not start, refer to
Troubleshooting
.)
Stopping the Engine
1. Release control bail so that trimmer head
stops rotation. Wait until rotating parts
stop completely before leaving operator’s
position.
2. Push throttle control lever to Stop.
3. If leaving unit unattended, disconnect
spark plug wire to prevent accidental
start-up.
TO OPERATE THE TRIMMER
1. Start the engine.
2. Set throttle control to Fast.
3. Hold the control bail against the
handlebar to engage the trimmer head.
4. When trimmer head is rotating at full
speed, move unit forward to trim.
TO TRAVEL TO ANOTHER WORK
AREA
When crossing driveways or bare areas,
release the control bail to stop trimmer head
rotation and push down slightly on the
handlebar to lift the trimmer head off the
ground. This prevents premature wear of the
trimmer head.
TRIMMING TIPS
• Operating the trimmer in Fast throttle
provides the best trimming performance.
• In heavy growth, walk slower.
• Do not push the trimmer into heavy
growth too fast.
• Do not trim on extremely steep slopes. Do
not trim on slopes when the ground is wet
or slippery. If you do not feel comfortable
on a slope, do not trim it.
• Keep the trimmer clear of dirt and grass
build-up.
• Install a new trimmer line when line is
worn to less than 4 inches (10.2 cm). See
Service and Adjustments
.
TO TRANSPORT UNIT
ALWAYS turn engine off when transporting on
truck or trailer. Tie unit down securely. Do not
tie down by linkages, guards, cables or other
parts that may be damaged.
CAUTION:
Before every use, clean
grass and debris from foam debris
screen and around muffler.
