MachineryHouse C6246, Instruction Manual

Page: 9 / 89

10
2. Unpacking and Installation
2-1 Points for Unpacking
For short distance transportation of this machine, fix it onto the truck by hemp rope:
while for long distance, packed by a wooden case or dispatched by container. Please
first to check if there is any damage on packing when arrive. After unpacking
carefully inspect whether it exists any injury or insufficiency. If any contact us
immediately for proper settlement or any of the damages of the machine will receive
no any compensation from us.
2-2 Unloading of the Machine
When the machine is unloaded from the car or to be moved, please proceed with
following steps (as illustrated 2-2)
1) Preparing two round sticks (long approx.830mm dia 40mm) insert into the
preserved holes on lathe bed. Then lift up with applying wires on both end of the
stick.
2) Lifting the machine by a crane.
3) Before lifting adjust the position of Lathe Apron and Tailstock to maintain the
balance of machine.
4) When the machine was shifted to its destination. always handle with care to put
it down. Don’t let go of it to hit the ground or it will affect the accuracy of the
machine.
Note: Machine weight can be seen in Specification Table.
5) For the adjustment of electric control, keep the distance between machine and
wall not less than 600mm.
illustration 2-2
Page 9 Instructions Manual for CL-60A (L604) 07/09/2017