6
Simplifying IoT from edge to enterprise
MACH-3 Installation and Configuration Manual
1.
Connect an Ethernet RJ45 cable to
Ethernet 1 as shown in Figure 1: Front
Panel View.
2.
Connect antennae as shown in Figure
1: Front Panel View using antennae
that meet the minimum configuration
specified in the Appendix on page 37.
3.
Open the micro-SIM/micro-SD card
access door and insert the micro-SIM
card in the SIM-Card slot as shown in
Figure 2: SIM Card Installation before
turning on the MACH-3 gateway.
4.
The gateway power connector is a
Molex Microfit 3.0 four pin connector
wired as shown in Figure 3. The four
pin connector accepts a 9 - 60 VDC
power supply input and a contact
closure input.
Pin 1: Contact Input common
Pin: 2 Contact Input
Pin: 3 Power (9- 60 VDC)
Pin: 4 Ground
2.3 Setting up MACH-3 Gateway
Figure 1: Front Panel View
2 Installing your MACH-3 Gateway
Power
(9-60 VDC)
Switch in(-)
Ethernet 1
Ethernet 2
Wifi/BT
USB
(Type A)
Cellular
(Main)
RS-232
(DTE)
DIV
GPS
GND
Switch in(+)
