i-
ALERT® Gateway Installation Guide
12/13
4
Safety and regulatory information
WARNING: Before you begin any of the procedures in this section, read the
safety and regulatory
information
that is shipped with your system. For additional best practices information, go to
www.machfu.com/regulatory_compliance
.
WARNING: If the
i-ALERT2
® Gateway is rewired using conduit, it must be installed by knowledgeable,
skilled personnel familiar with local and/or international electrical codes and regulations.
WARNING: The
i-ALERT2
®
Gateway is designed for use in wet environments given the AC out is
properly enclosed. The
i-ALERT2
®
Gateway enclosure is rated for an Ingress Protection (IP) rating of
IP68. Note that the electrical out must also provide environmental protection.
WARNING: When installing the
i-ALERT2
®
Gateway for DC operation, the responsible party or
integrator shall use the 12-57 VDC with a minimum of 13 W power rating.
WARNING: Ensure that the power source providing power to the
i-ALERT2
® Gateway is reliably
grounded and filtered such that the peak-to-peak ripple component is less than 10 percent of the input
DC voltage.
WARNING: To ensure the protection provided by the
i-ALERT2
®
Gateway is not impaired, do not use or
install the system in any manner other than what is specified in this manual.
5
Regulatory Notices
FCC Statement
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio communications. Operation of this
STATUS:
▲
indicates the
gateway is connected to a
cellular network.
SIGNAL STRENGTH:
Range of -
30 to -20 dbM is preferable.
SENSOR COUNT:
Number of i-
ALERTs connected to the
gateway
AWS IOT STATUS:
Show is the
gateway is connected to the i-
ALERT Ai Platform.
SENSOR LIST:
List of i-ALERT
sensors connected to the
gateway via a Bluetooth
