MACH ETH - User Manual
MACH SYSTEMS s.r.o.
Page
13
of
20
•
Short the boot pads together (a pair of tweezers can be used)
•
Connect the power supply - either USB or external
•
The device will enter the system bootloader
•
Release the boot pads
•
Firmware can be flashed as described in 5.6
•
Close the enclosure
The steps for Ethernet bootloader:
•
Disconnect the USB and the external power supply
•
Open the enclosure
•
Connect the power supply - either USB or external
•
Connect the Ethernet cable
•
Short the eth boot pads together (a pair of tweezers can be used)
•
The device will enter the Ethernet bootloader
•
Release the boot pads
•
Firmware can be flashed as described in 5.4
•
Close the enclosure
C.
With internet browser
•
Open Chrome internet browser
•
Type IP address (default IP address is 192.168.1.100) of the device in the
address bar
•
At the bottom of the page, click on the button Go to USB bootloader to enter
the system bootloader
o
Window with the short message is shown
o
Firmware can be flashed as described in 5.6
•
To enter Ethernet bootloader, click on Go to Ethernet bootloader
o
Window with short message is shown
o
Firmware can be flashed as described in 5.4
D.
Send protocol message
