4.8.3
Servicing Red Brake/Tail Lights
Replacing Red Brake/Tail Light Bulb
1. Remove two Phillips screws from
fi
xture, and remove
the plastic lens.
2. Replace bulb, and reinstall plastic lens and screws.
Bulb—Trade #1157.
Figure 4.236: Plastic Lens and Screws
Replacing Red Brake/Tail Light Fixture
1. Cut plastic cable ties (A) securing harness covering
to light.
2. Retrieve connections from inside harness covering
(approximately 6 in.
[150 mm] from light) and
disconnect wires (not shown).
If necessary,
remove tape.
3. Remove the four nuts (B) securing light to bracket and
remove light. Pull wires through hole in bracket.
4. Feed connectors of new light (not shown) through hole
in bracket, and position light onto bracket.
5. Install four nuts (B) and tighten.
6. Connect wires to connectors in harness, and re-secure
harness covering with tape and plastic cable ties (A)
as required.
Figure 4.237: Red Hazard Light and
Mounting Bracket
169820
226
Revision A
