MacDon R113 SP, Operator'S Manual

Page: 56 / 240

215009
42
Revision A
3.4.4 Attaching Hydraulic and Electrical Components
The procedure for attaching the header hydraulic and electrical components depends on the windrower model. Refer to
the appropriate procedure for instructions:
NOTE:
Headers are factory-configured for either M series or M1 series windrowers. M1 configured headers have a bent axis motor
while M series configured headers are fitted with a straight in line motor.
Hydraulic conversion kits are available (motors, hoses, etc.) to convert a factory configured header from M1 to M series
application and vise versa. If required, order Header Drive Conversion Kit.
•
Connecting Header Hydraulics and Electrical
–
M1 Series Windrowers, page 42
•
Connecting Header Hydraulics and Electrical
–
M155 and M155E4 SP Windrowers, page 45
Connecting Header Hydraulics and Electrical
–
M1 Series Windrowers
1027018
Figure 3.50: Hydraulic Drive Kit (MD #B6621)
NOTE:
Hydraulic drive kit (A) (MD #B6621) is required for an R113 SP
Disc Header that is originally configures for use with an M155 or
M155
E4 to operate correctly on an M1 Series Windrower. To
order this kit, contact your MacDon Dealer.
1027218
A
Figure 3.51: Low Pressure Case Drain Kit (MD #B6698)
NOTE:
When connecting the R113 SP to an M1240 windrower, the Low
Pressure Case Drain kit (MD #B6698) (A) must be installed onto
the M1240. This kit contains an alternative case drain line which
is routed directly to the hydraulic reservoir via unique set of
1/2 in. hydraulic couplers.
1. Move the windrower
’
s left (cab-forward) platform to the OPEN position. Refer to your windrower operator
’
s manual
for instructions.
2. Retrieve hydraulic hoses from header.
OPERATION