215333
294
Revision A
4.9
Replacing Shield
–
No Conditioner
4.9.1
Removing Discharge Shield
–
No Conditioner
Follow these steps to remove the shielding installed on a rotary disc pull-type configured without a conditioner:
1015037
B
A
Figure 4.366: Rotary Disc Pull-Type with Transport
1.
Raise the rotary disc pull-type fully and extend the center-
link to maximize the space between shield (A) and carrier
frame (B).
1023734
1023734
A
Figure 4.367: Lift Cylinder Lock-Out Valves
2.
Close lift cylinder lock-out valves (A) on both sides of the
rotary disc pull-type. Valve handles should be in the closed
position (90° angle to the hose).
1022903
A
B
C
A
Figure 4.368: Header
–
View from Left
3.
Remove four M16 hex head bolts (A), nuts, and flat washers
securing shield (B) to panel (C) on the rotary disc pull-type.
