215333
247
Revision A
Installing Cross Driveline
WARNING
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove the key
from the ignition before leaving the operator
’
s seat for any reason.
1.
Shut down the engine, and remove the key from the
ignition.
1015179
1015179
A
Figure 4.259: Lower Left View of Rotary Disc Pull-Type
2.
Open the cutterbar doors to install cross driveline (A) from
inside the rotary disc pull-type. For instructions, refer
to
1015171
A
B
Figure 4.260: Cross Driveline Yoke
3.
Position driveline yoke (B) as shown on both ends of the
cross driveline.
4.
Install taper pin so groove on pin is aligned with groove
on shaft.
5.
Install nut (A) onto taper pin and torque to 150 Nm
(110 lbf·ft). Pin must be recessed 9
–
11 mm (3/8
–
7/16 in.)
inside the yoke.
IMPORTANT:
Check taper pin torque every 25 hours until it stops moving,
then check before every season.
1015181
A
B
Figure 4.261: Cross Driveline Shield
6.
Slide driveline shields (B) over the yokes at both ends of the
driveline, and secure them with clamps (A).
7.
Close the cutterbar doors. For instructions, refer to
