215333
239
Revision A
Installing Clutch Driveline
WARNING
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove the key
from the ignition before leaving the operator
’
s seat for any reason.
1.
Shut down the engine, and remove the key from the ignition.
2.
Install driveline guard onto driveline (if previously removed). For instructions, refer to
Installing Driveline Guards, page
1008474
A
Figure 4.239: Driveline and Gearbox
3.
Position driveline onto the gearbox shaft as shown at right.
4.
Clean the taper pin threads.
5.
Install taper pin into yoke with groove on pin aligned with
groove in shaft. Ensure there is no grease on threads after
inserting pin through yoke.
6.
Secure pin with nut (A). Torque to 150 Nm (110 lbf·ft). Pin
should be flush with yoke.
IMPORTANT:
Check taper pin torque every 25 hours until it stops moving,
then check before every season.
1008473
A
Figure 4.240: Driveline Shield Cone
7.
Slide the shield cone to the gearbox and secure with two
lever clamps (A).
