215333
185
Revision A
1027053
A
B
C
Figure 4.112: Left Outboard Rock Guard
–
View
from Rear
4.
Locate rock guard (B) on the bottom outboard end of the
cutterbar. There is one guard on each end of the cutterbar.
5.
Remove the two hex head screws (A), washers, and lock
nuts (C) securing rock guard (B) to the cutterbar assembly.
1027241
A
B
C
Figure 4.113: Left Outboard Rock Guard
–
Side View
6.
Remove bolt and washers (A).
7.
Loosen bolt (B).
8.
Remove rock guard (C) by sliding it forward.
9.
Repeat Steps
to
at the opposite
side of the cutterbar.
Installing Outboard Rock Guards
DANGER
To avoid bodily injury or death from unexpected start-up or fall of a raised machine, stop engine, remove key, and
engage lift cylinder lock-out valves before going under machine for any reason.
1.
Check and remove any cutterbar debris that could obstruct installation of the outboard rock guard.
2.
Raise the header fully.
3.
Shut down the engine, and remove the key from the ignition.
4.
Engage the lift cylinder lock-out valves. For instructions, refer to
.