215333
184
Revision A
Installing Inboard Rock Guards
1003640
A
Figure 4.110: Inboard Rock Guards
1.
Guide inboard rock guard onto cutterbar until tabs (A) sit
on top of the cutterbar and bottom back bolt holes line up.
1003622
A
Figure 4.111: Inboard Rock Guards
2.
Install two hex head screws, washers, and lock nuts (A).
Torque hardware to 68 Nm (50 lbf·ft).
NOTE:
Lock nuts (A) are installed on top.
Removing Outboard Rock Guards
DANGER
To avoid bodily injury or death from unexpected start-up or fall of a raised machine, stop engine, remove key, and
engage lift cylinder lock-out valves before going under machine for any reason.
WARNING
Exercise caution when working around the blades. Blades are sharp and can cause serious injury. Wear gloves when
handling blades.
1.
Raise the header fully.
2.
Shut down the engine, and remove the key from the ignition.
3.
Engage the lift cylinder lock-out valves. For instructions, refer to
.
