215333
106
Revision A
Positioning Rear Baffle
–
Roll Conditioner
The rear baffle is used in conjunction with the forming shields to determine the height and width of the windrow. It is
located immediately behind and above the conditioning rolls and can be positioned to do the following:
•
Raise the baffle and direct crop flow into forming shields for a fluffier, narrower or moderate-width windrow.
•
Lower the baffle and direct crop downward to form a flatter, wider windrow.
To position the rear baffle, follow these steps:
WARNING
To avoid injury or death from unexpected start-up of machine, always stop the engine and remove the key from the
ignition before leaving the operator
’
s seat for any reason.
1011090
A
B
C
Figure 3.131: Right End of Conditioner
1.
Remove lynch pin (A) securing rear baffle adjustment
lever (B) to bracket (C).
2.
Pull rear baffle adjustment lever (B) inboard to disengage
from bracket (C).
3.
Position rear baffle adjustment lever (B) as follows:
•
Move the lever forward to raise the baffle
•
Move the lever backward to lower the baffle
4.
Release rear baffle adjustment lever (B) so that the tab
engages the middle notch in bracket (C).
5.
Secure baffle adjustment lever (B) with lynch pin (A).
