![background image](http://html2.mh-extra.com/html/macdon/pw8/pw8_operators-manual_3429414046.webp)
214657
32
Revision A
Figure 3.8: Removing Endshield
3.
Swing endshield (A) fully back and loosen nuts (B) on
clips (C) at back of endshield so clips disengage slots in
header frame.
4.
Move endshield (A) away from header.
3.3.4
Installing Left Endshield
Figure 3.9: Attaching Endshield
1.
Hold endshield (A) up to frame and insert clips (C) into
slots in header frame.
2.
Tighten nuts (B) on clips (C) just enough to hold
endshield in place.
Figure 3.10: Aligning Endshield
3.
Close endshield (A) ensuring magnet (B) and stop (C)
in header frame are aligned. This will ensure that
latch (D) aligns with receptacle (E).
NOTE:
Latch (D) and magnet (B) positions are factory-set and
should not require adjustment.
4.
If adjustment is necessary, loosen nuts on clips installed
in Step
and reposition the endshield (A).
Tighten nuts but do
NOT
overtighten. Over tightening
nuts can damage the endshield.
Summary of Contents for PW8
