![background image](http://html2.mh-extra.com/html/macdon/pw8/pw8_operators-manual_3429414275.webp)
214657
261
Revision A
5.12.4
Replacing Lamp Housing
Transport lights are an important safety feature. Replace housing if cracked or broken.
DANGER
To avoid bodily injury or death from unexpected startup of machine, always stop engine and remove key
from ignition before leaving operator
’
s seat for any reason.
1.
Lower header to the ground, shut off combine, and remove key from ignition.
Figure 5.212: Transport Light
2.
Pull wiring harness (A) out of lamp bracket, and locate
connectors inside the wiring harness.
3.
Disconnect light wiring from harness.
4.
Remove four nuts (B), and remove lamp (C) from
bracket.
5.
Install new lamp (C) on bracket, and secure with four
nuts (B).
6.
Connect lamp wiring to harness (A), and route wires
inside plastic covering. Seal with black tape.
7.
Ensure that wiring harness is not damaged, and secure
harness inside lamp bracket.
8.
Check operation of new lamp.
Summary of Contents for PW8
