![background image](http://html2.mh-extra.com/html/macdon/pw8/pw8_operators-manual_3429414273.webp)
214657
259
Revision A
5.12
Lights
The transport lights, located at each end of the header, are used when driving the combine on the road with the
header attached.
•
Use electrical tape and wire clips to prevent wires from dragging or rubbing.
•
Keep lights clean, and replace defective bulbs.
•
Replace the light housing if it is cracked or broken.
5.12.1
Adjusting Transport Lights
DANGER
To avoid bodily injury or death from unexpected startup of machine, always stop engine and remove key
from ignition before leaving operator
’
s seat for any reason.
1.
Lower header to the ground, shut off combine, and remove key from ignition.
2.
If repositioning is required, swivel the lights with hand force.
Figure 5.209: Transport Light
3.
If the swivel is too loose or too tight, loosen jam nut (A)
and turn nut (B) so the light maintains its position and
can be moved with hand force. Do
NOT
overtighten.
4.
Tighten jam nut (A).
Summary of Contents for PW8
