![background image](http://html2.mh-extra.com/html/macdon/pw8/pw8_operators-manual_3429414245.webp)
214657
231
Revision A
Figure 5.149: Left Side Front Deck
–
Right Side
Opposite
9.
Secure bearing (A) with lock nuts (B).
10. Install lock collar (C) onto bearing, and rotate lock collar
clockwise (counterclockwise for right side) until tight.
11. Tighten the setscrew using a 6 mm hex key.
12. Remove wooden block.
13. Align the draper deck rollers. Refer to
.
14. Tension the drapers. Refer to
Aligning Front Draper Deck Rollers
Draper roller alignment is necessary for proper draper tracking. Perform this procedure after replacing a roller
bearing.
DANGER
To avoid bodily injury or death from unexpected startup of machine, always stop engine and remove key
from ignition before leaving operator
’
s seat for any reason.
1.
Lower the header to the ground, shut down the combine, and remove the key from the ignition.
2.
Open left endshield. Refer to
3.3.1 Opening Left Endshield, page 29
.
Figure 5.150: Front Hydraulic Motor
3.
Remove the front hydraulic motor (A). Refer to
Removing Front Hydraulic Motor, page 180
4.
Release the draper belt tension. Refer to
Summary of Contents for PW8
