![background image](http://html2.mh-extra.com/html/macdon/pw8/pw8_operators-manual_3429414240.webp)
214657
226
Revision A
Figure 5.137: Left Side Rear Deck Idler Roller
10. Tighten the locking collar (A) and the three nuts (B)
attaching the bearing flange to the frame on the left side
of the header.
Figure 5.138: Right Side Rear Deck Idler Roller
11. Tighten the locking collar (A) and the three nuts (B)
attaching the bearing flange to the frame on the right
side of the header.
12. Tighten locking bolt (C).
13. Recheck measurement in Step
to ensure
nothing moved while tightening the nuts on each side of
the header.
14. Tension the draper belt. Refer to
15. Reinstall the front hydraulic motor. Refer to
Front Hydraulic Motor, page 181
16. Close the left endshield. Refer to
.
Replacing Drive Roller Bearing on Left Side of Front Deck
DANGER
To avoid bodily injury or death from unexpected startup of machine, always stop engine and remove key
from ignition before leaving operator
’
s seat for any reason.
1.
Lower the hold-down fully.
2.
Lower header to the ground until the two float springs are loose.
3.
Stop the engine, and remove the key from the ignition.
4.
Open the left endshield. Refer to
3.3.1 Opening Left Endshield, page 29
5.
Release the draper belt tension fully. Refer to
Summary of Contents for PW8
