214657
191
Revision A
Figure 5.52: Driven Sprocket
4.
Remove three M10 hex bolts (A) from tapered
bushing (D) in sprocket (C) using a 16 mm wrench.
5.
Reinstall two of the M10 hex bolts (A) into the threaded
holes (B) in the tapered bushing (D).
6.
Turn bolts into tapered bushing equal amounts in half-
turn increments until the tapered bushing (D)
becomes loose.
7.
Remove tapered bushing (D) and sprocket (C)
from shaft.
8.
Retain keys from driveshaft and tapered bushing.
9.
Clean and inspect components. Replace worn or
damaged parts.
Installing Driven Sprocket
Figure 5.53: Driven Sprocket
1.
Apply anti-seize compound to the mating surfaces of
driveshaft (A), tapered bushing (B), and sprocket (C).
2.
Install keys into driveshaft (A) and tapered bushing (B).
3.
Insert tapered bushing (B) into sprocket (C) while
aligning key with keyway in sprocket.
4.
Align key in driveshaft (A) with keyway in tapered
bushing (B), and slide bushing and sprocket (C) onto
driveshaft.
Figure 5.54: Driven Sprocket
5.
Remove two M10 hex bolts from threaded holes (B) in
tapered bushing (D).
6.
Reinstall three M10 hex bolts (A) through tapered
bushing (D) and into sprocket (C). Do
NOT
tighten.
Summary of Contents for PW8
