262171
272
Revision A
1019559
A
Figure 5.163: GSL
3.
Use REEL SPEED switches (A) on GSL to set reel speed.
NOTE:
The desired speed increases 1 rpm (0.1 mph or 0.2 km/h if
set to mph or km/h) per momentary press, or continuous
scrolling if switch is pressed and held.
Setting Auger Speed
The auger speed can only be adjusted independently if the differential auger-reel control is engaged. This feature is
standard on A40DX Grass Seed Auger Headers, but optional on A40DX Auger Headers without the Grass Seed option.
If the differential auger-reel control is not engaged, auger speed is automatically adjusted when you adjust reel speed.
•
To turn on differential auger-reel control and adjust the auger speed, begin with Step
•
If differential auger-reel control is on, proceed to Step
for instructions about adjusting auger speed
NOTE:
When the differential auger-reel control is engaged, the minimum/maximum reel speed is dependent on the auger speed.
In some cases, in order to have the reel run slower or faster, you may have to decrease or increase the auger speed.
ϭϬϰϮϬϵϱ
A
B
C
Figure 5.164: HarvestTouch
™
Display
1.
To access the HEADER SETUP page from the home page or
from a header run page, press MENU (A) to view options.
2.
Press SETUP (B) followed by HEADER (C). The HEADER page
opens and lists all of the headers that have been attached
to the windrower.
NOTE:
The F4 shortcut button on the operator
’
s console also will
display the HEADER SETUP page.
