262171
267
Revision A
ϭϬϰϮϬϵϯ
A
B
Figure 5.154: HarvestTouch
™
Display
Display functions
•
As the swath compressor moves up or down, target
value (A) changes, windrower with swath compressor
icon (B) flashes.
•
Windrower icon (B) is solid when the target height is
achieved.
•
Value (A) is 0 when the swath compressor fully raised.
•
Icon (B) is not visible and automation is disabled without a
header attached. Swath compressor height can still be
adjusted.
Swath compressor automated functions: header engaged
•
The swath compressor lowers to target height at a ground speed higher than 2.5 km/h (1.6 mph).
•
The swath compressor fully rises as the ground speed transitions through 1.6 km/h (1 mph) during deceleration.
•
The swath compressor fully rises when the header is disengaged at a ground speed higher than 1.6 km/h (1 mph).
•
An IMPORTANT message to raise the swath compressor appears on the HarvestTouch
™
Display accompanied by a tone
when the GSL is moved out of PARK in engine-forward mode if the swath compressor is not fully raised.
Engage the swath compressor lock when the swath compressor is not in use, or when the windrower is in engine-forward
mode. For instructions, refer to
Locking and Unlocking Swath Compressor, page 267
Locking and Unlocking Swath Compressor
The swath compressor lock is located on the left cab-forward side of the swath compressor frame. When engaged, the lock
prevents the compressor shield from lowering.
1021929
A
Figure 5.155: Swath Compressor Lock
1.
Turn lock handle (A) clockwise to engage the swath
compressor lock under the following conditions:
•
Swath compressor is not in use
•
Windrower is being serviced
•
Windrower is in engine-forward mode
2.
Turn handle (A) counterclockwise to disengage the lock
before operating the swath compressor.