MacDon M205, Operator'S Manual

Page: 356 / 514

214603
336
Revision A
Adding Coolant
Check the coolant level in the coolant recovery tank daily. Add coolant if the tank is less than one-half full.
NOTE:
For coolant specifications, refer to the inside back cover of this manual.
DANGER
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and
remove the key from the ignition before leaving the operator
’
s seat for any reason.
CAUTION
To avoid personal injury from hot coolant, do NOT turn radiator cap until engine cools.
NOTE:
Do NOT add coolant directly into the radiator except when changing coolant.
To add coolant to the coolant recovery tank, follow these steps:
1. Stop the engine and remove the key.
2. Open the hood. Refer to 5.2.3 Opening Hood (Highest Position), page 286 .
3. Open the platform. Refer to 5.3.1 Opening Platforms (Standard Position), page 288 .
1009941
A
B
Figure 5.90: Coolant Recovery Tank
4. Remove cap (A) from coolant recovery tank (B).
5. Add coolant at a rate not exceeding 3 gallons per
minute until the recovery tank is one-half full.
CAUTION
Before starting the machine, check to be sure all
bystanders have cleared the area.
6. Start engine and run at high idle for approximately
20 minutes or until the engine temperature reaches
85°C (185°F).
7. Check the coolant level again and add coolant until the
recovery tank is one-half full.
8. Replace cap (A).
9. Close the platform. Refer to 5.3.2 Closing Platforms (Standard Position), page 289 .
10. Close the hood. Refer to 5.2.4 Closing Hood (Highest Position), page 287 .
MAINTENANCE AND SERVICING