215104
196
Revision A
6.3
Attaching an A Series Auger Header
A30D, A30S, and A40D Auger Headers can be attached to an M155
E4
Self-Propelled Windrower.
1000777
Figure 6.33: M155
E4
and A40D Auger Header
The M155
E4
Self-Propelled Windrower is factory-equipped to
run an A Series Auger Header.
Windrowers equipped with A Series hydraulics have four
header-drive hoses on the left side.
The attachment procedure varies depending on the type of
center-link installed on the windrower. Refer to the following
instructions based on the type of center-link installed on your
windrower:
•
6.3.1 Attaching an A Series Auger Header
Link with Optional Self-Alignment, page 196
•
6.3.2 Attaching an A Series Auger Header
Link without Self-Alignment, page 202
6.3.1
Attaching an A Series Auger Header
–
Hydraulic Center-Link with Optional Self-
Alignment
WARNING
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove the key
from the ignition before leaving the operator
’
s seat for any reason.
1.
Shut down the engine, and remove the key from the ignition.
1000778
A
B
C
Figure 6.34: Header Boot
2.
Remove hairpin (A) from clevis pin (B) and remove clevis
pin from header boots (C) on both sides of the header.
