215676
436
Revision A
1021082
A
Figure 5.209: Drive Wheel Nuts
3.
Line up the holes in the rim with the studs on the wheel
drive hub. Install wheel nuts (A).
IMPORTANT:
To avoid damaging the wheel rims and studs, tighten the
nuts by hand. Do
NOT
use an impact wrench. Do
NOT
apply
lubricant or anti-seize compound to the threads of the
wheel studs. Do
NOT
overtighten the wheel nuts.
4.
Remove the lifting device.
5.
Torque the drive wheel nuts. For instructions, refer to
Tightening Drive Wheel Nuts, page 431
.
6.
Raise the windrower, and remove the jack. For instructions,
refer to
Lowering Drive Wheel, page 436
Lowering Drive Wheel
Once the drive wheel is secured to the wheel hub, the windrower can be lowered.
CAUTION
Jack stand must be capable of supporting a minimum of 2268 kg (5000 lb.).
1016454
A
B
Figure 5.210: Drive Wheel Leg Jack Point
1.
Place a jack under leg jack point (A), and raise the drive
wheel slightly off of the jack stand.
2.
Remove the jack stand from under cylinder lift mount (B).
Lower the drive wheel to the ground.
3.
Remove the jack.
