215676
202
Revision A
1018464
A
B
Figure 4.84: Operator Console
1.
To engage the header:
a.
Move throttle (A) to adjust the engine speed to idle.
b.
Push down on the center of HEADER DRIVE switch (B),
and then pull it up to engage the header drive. A slight
delay between the switch being activated and the
header beginning operation is normal.
2.
To disengage the header:
a.
Push HEADER DRIVE switch (B) down to disengage the
header drive.
Reversing Header
The header can be reversed using a switch on the operator
’
s console. You may wish to reverse the header to help clear an
obstruction.
NOTE:
The optional hydraulic reversing kit must be installed.
IMPORTANT:
Hose plumbing to the reverser block is specific to the header type. To prevent damage to the reel on D and D1 Series
Draper Headers, refer to the reverser kit installation instruction MD #169213 when switching from an auger header to a
draper header on the same windrower. The instruction can be accessed on the dealer portal.
•
Reverses knife and conditioner on D and D1 Series Draper Headers.
•
Reverses reel, auger, knife, and conditioner on A Series Auger Headers.
1000736
A
B
Figure 4.85: Operator Console
1.
Push down and hold HEADER DRIVE REVERSE button (A)
and pull up on HEADER DRIVE switch (B). The cab display
module (CDM) will display the message HEADER REVERSE.
2.
Release REVERSE button (A) to stop the header.
3.
Push down HEADER DRIVE switch (B) to the OFF position.
This will allow you to restart the header.
NOTE:
To engage the header drive, first push down, and then pull
up on the HEADER DRIVE knob.
4.4.5
Adjusting Header Angle
Header angle is the term used to describe the position of the cutterbar relative to the ground. The angle of the header can
be changed as needed to suit different harvesting conditions.
Refer to the header operator
’
s manual for the recommended header angle settings for your particular header.
