WINDROWER OPERATION
Form 169017 / 169087 / 169095
58
Revision C
NOTE
Fill fuel tank daily, preferably at the end of
the day's operation to help prevent
condensation in the tank. Tank Capacity is
97 U.S. Gallons (378 L).
IMPORTANT
Do not fill tank completely as space is
required for expansion. A filled tank could
overflow if exposed to a rise in temperature,
such as direct sunlight.
IMPORTANT
Do not allow tank to empty. Running out of
fuel can cause air locks and/or
contamination of the fuel system. Refer to
Section 7.8.6 or 7.9.6
Fuel System
for
priming procedures.
6.3.5.6 Engine
Temperature
The normal engine operating temperature range is
180° - 225°F (82° - 107°C), and is indicated by a
gauge on the Operator’s console. If the
temperature exceeds 230°F (110°C), an ongoing
intermittent tone will be heard and the CDM will
flash “ENGINE TEMP”. Stop the engine
immediately and determine cause. The tone will
stop and the CDM will return to normal when the
temperature drops below 225°F (107°C).
6.3.5.7
Engine Oil Pressure
The nominal engine oil pressure is 10 psi (69 kPa)
at low idle, and 55.1 psi (380 kPa) at maximum
rated speed.
If the oil pressure drops below 7.5 psi (52 kPa), a
continuous loud tone will sound, and the CDM
display will flash “ENGINE OIL PRESS”.
Shutdown the engine immediately if warning
occurs while operating, or if it continues for more
than a few seconds after engine startup.
6.3.5.8 Electrical
IGNITION
ENGINE READING
INDICATED
CONDITION
On
Running
13.8 - 15.0
Normal.
> 16.0
See Note
Regulator Out of
Adjustment.
< 12.5
See Note
Alternator Not
Working or
Regulator Out of
Adjustment.
Shutdown 12.0 Battery
Normal.
NOTE
Display flashes voltage reading with single
loud tone. Repeats every 30 minutes until
condition fixed.
The electrical system voltage is displayed on the
CDM when selected with the select button on the
GSL handle or the select switch on the CDM.
The display indicates the condition of the battery
and alternator. Refer to table above.
6.3.5.9
Engine Warning Lights
There are four engine warning lights that
illuminate if abnormal conditions occur while the
engine is running. The engine warning lights
should not be illuminated under normal operating
conditions.
OPERATING RANGE
DISPLAY
Displays Malfunction Code
Refer to Error Codes at End of this Manual
CAUTION
Illuminates Yellow
Prompt Attention Is Required.
Refer to Display Code
STOP
Illuminates Red
Stop Engine Immediately
Refer to Display Code
WATER IN FUEL
Illuminates Yellow
Service Recommended
INTAKE AIR PREHEAT
M200 ONLY
Illuminates Yellow
Wait To Start Engine
