214735
59
Revision A
4.1.12
Checking and Adding Wheel Drive Lubricant
WARNING
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and
remove the key from the ignition before leaving the operator
’
s seat for any reason.
CAUTION
Park on a flat, level surface with the header on the ground, the ground speed lever in PARK position, and
the steering wheel in locked position (centered). Wait for the HPT to beep and display a red P symbol to
confirm the park brakes have engaged.
1.
Park the windrower on level ground.
1007544
A
B
C
Figure 4.24: Drive Wheel Hub
2.
Position windrower so plugs (A) and (B) are horizontally
aligned with the center (C) of the hub.
3.
Stop the engine, and remove the key.
4.
Remove plug (A) or (B). The lubricant should be visible
through the port or running out slightly.
5.
If necessary, add lubricant until lubricant runs out from
the open port (A) or (B). For lubricant specifications,
refer to
5.1 Lubricants, Fluids, and System Capacities,
NOTE:
The type of lubricant used after the first lubricant
change is different from the factory-supplied lubricant.
6.
Reinstall plugs and tighten.
