MacDon HC10, Original Instruction

Page: 53 / 242

215126
31
Revision A
1002661
A
B
Figure 3.36: Conditioner Lug
20. Carefully lower the windrower lift legs until lugs (A) on the
conditioner are seated in the U-shaped brackets (B) on
header.
21. Ensure the conditioner is seated properly in the brackets
before you disconnect from the windrower.
22. Disconnect the windrower from the HC10.
23. Shut down the engine, and remove the key from
the ignition.
1031015
B
C
A
E
D
Figure 3.37: Conditioner
–
Left Side
24. Remove bolt and nut (A) attaching swing arm (B) to
bracket (C).
25. Loosen bolt and nut (D) enough to rotate bracket (C).
26. Open latch (E) and remove swing arm (A).
1031016
C
A
D
E
B
Figure 3.38: Lifting Arm
–
Left Side
27. Place lifting arm (A) into storage position as shown.
28. Reattach lift arm (A) to bracket (B) using nut and bolt (C).
Leave hardware loose.
29. Secure lifting arm using L-pin (D).
NOTE:
Rotate pin (D) to align the key-hole slot.
30. Tighten hardware (E) to secure bracket (B) to the
conditioner. Tighten hardware (C) to secure lift arm (A) to
bracket (B).
31. Repeat Step 24, page 31 to Step 6, page 29 for the other
lifting arm.
UNLOADING AND ASSEMBLY