MacDon HC10, Original Instruction

Page: 41 / 242

215126
19
Revision A
3.4 Installing Deck Brackets
Proceed to the section applicable to the type of header:
•
D115, D120, and D125: Refer to 3.4.1 Installing Deck Brackets
–
D115, D120, and D125, page 19 .
•
D60, D65, and D130: Refer to 3.4.2 Installing Deck Brackets
–
D60, D65, and D130, page 22 .
3.4.1 Installing Deck Brackets
–
D115, D120, and D125
To install the deck brackets onto the header, follow these steps:
1005095
A
B
Figure 3.8: Lower Deck Bracket
–
Right Side
1. Retrieve the following parts from the loose parts package
shipped with MD #B4799:
•
Left bracket
•
Right bracket
•
Two 1/2 in. flange nuts
•
Two 1/2 x 1 1/4 in. carriage bolts
Install two lower brackets (A) and onto the inside of both
center header legs with two 1/2 x 1 1/4 in. carriage bolts
and two 1/2 in. flange nuts (B) in each bracket.
1031036
A
B
E
C
D
Figure 3.9: Upper Bracket
–
15-Foot Header Shown
2. Retrieve the following parts from the loose parts package
shipped with MD #B4799:
•
Right bracket
•
One spacer
•
Two 5/8 in. flange nuts
•
One 5/8 x 7 1/2 in. hex bolt
Install right upper bracket (A) and spacer (B) on the right
center leg as shown in illustration at the right, and install
one 5/8 in. flange nut (C).
NOTE:
On headers with a sheet metal hose cover, install bolts from
the outboard side.
3. Install 5/8 x 7 1/2 in. hex bolt (D) through the bracket and
spacer and secure with a one 5/8 in. flange nut (E).
4. Tighten both nuts (C) and (D).
UNLOADING AND ASSEMBLY