MacDon HC10, Operation And Parts Manual

Page: 43 / 156

UNLOADING AND ASSEMBLY
10. Route the conditioner pressure hose (A) (orange cable
tie) behind the motor and attach it to the coupler (B).
Figure 3.43: Conditioner Hydraulics
11. Loop the conditioner return line (A) up over top of the
couplers and connect to the pressure port (B) on the
motor. Ensure all hoses will be clear of windrower tires.
Figure 3.44: Conditioner Hydraulics
3.7.2 Attaching Hydraulics: All Headers Except 15-Foot
To attach hydraulics to all headers (not including 15-foot),
follow these steps:
1. Identify the hydraulic coupler components shown in
Figure
3.45: Hydraulic Coupler Components, page 33 .
2. Remove hose cover (A) from left-hand coupler mount.
3. Disconnect the side draper return hose (C) at the main
return tee (refer to item [E] in Figure
3.45: Hydraulic
Coupler Components, page 33 ).
Figure 3.45: Hydraulic Coupler Components
A - Hose Cover B - Coupler Mount
C - Side Draper Return D - LH Draper Case Drain
E - To Side Drapers (Pressure) F - Case Drain Coupler
G - Knife/Conditioner Pressure H - Header Return
214033
33
Revision A