NOTE:
The FM100 Float Module is equipped with a multicoupler that connects to the combine. If your combine is
equipped with individual connectors, a multicoupler kit (single-point connector) must be installed. Refer
to Table
4.2 Multicoupler Kits, page 254
for a list of kits and installation instructions that are available
through your combine Dealer.
Table 4.2 Multicoupler Kits
Combine
Kit Number
Challenger
71530662
Gleaner R/S Series
71414706
Massey Ferguson
71411594
8. Disengage both header
fl
oat locks by pushing down
fl
oat lock handle (A) and placing it under the hook
(UNLOCK).
Figure 4.69: Float Lock in UNLOCK Position
9. Raise the handle (A) to release the multicoupler (B)
from the
fl
oat module.
Figure 4.70: Float Module Multicoupler
147831
254
Revision A
Summary of Contents for FlexDraper FD1 Series
